HomeAbout UsContactExhibitionsFeedbackNewsNewsletterOrderingPress ReleasesProductsRSS FeedSupport

Trimble Lassen iQ

Low Power, Micro Sized 12 Channel GPS Receiver

Ideal Solution For Mobile Applications

		3.3V for battery powered apps Trimble quality at low cost 12-channel operation Operating temp -40° to +85°C Next-generation RF technology 26 mm x 26 mm x 6 mm Sized for portable devices TSIP, TSIP, DGPS & NMEA support Different antennas available Starter kit available Ultra-low power: 90mW @ 3.3V Datasheet/Manual: Trimble Lassen iQ Datasheet - PDF Trimble Lassen iQ Manual - PDF

Introduction

Trimble's Lassen® iQ module is one smart buy. It adds powerful, 12-channel GPS functionality to your mobile product in a postage-stamp-sized footprint with ultra-low power consumption and extreme reliability - all at a very economical price.

Designed for portable handheld, battery-powered applications such as cell phones, pagers, PDAs, digital cameras, and many others, the module is also ideal for standard GPS applications such as tracking.

The 12-channel Lassen iQ module is fully compatible with Trimble's popular Lassen SQ module. Using Trimble's breakthrough, patented FirstGPS® architecture, the module delivers complete position, velocity and time (PVT) solutions for use in the host application.

Top Performance

The Lassen iQ module features two GPS signal sensitivity modes: Standard and Enhanced. With Enhanced mode enabled, the module automatically switches to higher sensitivity when satellite signals are weak. The module also supports TSIP download of critical startup information for fast acquisition. This aided GPS (A-GPS) startup provides hot start performance for each power-up.

The Lassen iQ module is the only stamp-sized GPS product that supports the four most popular protocols: DGPS (RTCM), TSIP (Trimble Standard Interface Protocol), TAIP (Trimble ASCII Interface Protocol) and NMEA 0183. The Lassen iQ module combines Trimble performance and quality with low cost. With an MTBF (mean time between failures) figure of 60 years, it is one of the most reliable GPS receivers on the market.

Hardware

A metal shield encloses the module for protection and ease of handling. The package has a small form factor, (approximately 26 mm x 26 mm, including the shield). It typically requires less than 90 mW of power at 3.3 VDC. The highly integrated module is a miniature board containing Trimble GPS hardware core based on our Colossus® RF ASIC and IO-TS digital signal processor (DSP), a 32-bit RISC CPU and flash memory.

Lassen iQ Starter Kit

The Lassen iQ module is compatible with active, 3.3-VDC antennas. Three such antennas are available from Trimble and are recommended for use according to your application; see below for antenna details. The module provides both antenna open and short detection plus antenna short protection.

Starter Kit

The Lassen iQ Starter Kit provides everything you need to get started integrating state of the art GPS capability into your application.

Specification
Key Features:
12-channel simultaneous operation Ultra-low power consumption: less than 90 mW (27 mA) @ 3.3 V Dual sensitivity modes with automatic switching Aided GPS through TSIP Antenna open and short circuit detection and protection Compact size: 26 mm W x 26 mm L x 6 mm H Supports NMEA 0183, TSIP, TAIP, DGPS protocols Trimble quality at low cost
Performance:
General:	L1 frequency, C/A code (SPS), 8-channel, continuous tracking receiver, 32 correlators
Update rate:	TSIP @ 1Hz; NMEA @ 1Hz; TAIP @ 1Hz
Accuracy:	Horizontal: <6 meters (50%), <9 meters (90%) Altitude: <11 meters (50%), <18 meters (90%) Velocity: 0.06 m/sec PPS: ±95 nanoseconds
DGPS accuracy:	Position: 2m CEP (50%) Velocity: 0.06 m/sec (1 sigma)
Acquisition:	Hot start: <15 seconds (90%) Warm start: <42 seconds (90%) Cold start: <130 seconds (90%) Cold start requires no initialization. Warm start requires last position, time and almanac saved in battery back-up memory. Hot start requires that the ephemeris also saved.
Reacquisition:	<2 seconds (90%) (after signal loss)
Dynamics:	Acceleration: 4g (39.2 m/sec2) Motional Jerk: 20 m/sec3
Operational limits:	Altitude <18,000m or velocity <515 m/sec Either limit may be exceeded but not both.
Environmental:
Operating temp:	– 40°C to +85°C
Storage temp:	–55°C to +100°C
Vibration:	0.008 g2/Hz 5Hz to 20Hz 0.05 g2/Hz 20Hz to 100Hz 3dB/octave 100Hz to 900Hz
Operating Humidity:	5% to 95% R.H. non-condensing, @ +60°C
Electrical:
Prime power:	+3.0 VDC to +3.6 VDC (3.3 V typ.)
Consumption:	GPS board only: 95mA, 0.47W With antenna: 120mA, 0.60W
Back-up power:	+3.2 to +5V DC Up to 20µA (varies on voltage and temperature). A sample module consumes 5µA @ +3.0V, +25°C
Antenna power:	3V at 25mA available Open-circuit detection Short-circuit protection
Interface Characteristics:
Serial ports/1PPS:	CMOS TTL levels
Supported Protocols:	TSIP @ 9600 baud, 8-Odd-1 (configurable) TAIP @ 4800 baud, 8-None-1 (configurable) NMEA 0183 v2.1 @ 4800 baud, 8-None-1 (configurable) RTCM SC-104 @ 4800 baud, 8-None-1
NMEA messages:	GGA, VTG, GLL, ZDA, GSV, GSA and RMC Messages selectable by TSIP command; selection stored in non-volatile memory
Other:
Dimensions:	3.25" x 1.25" x 0.40" (82.6mm x 31.2mm x 10.2mm) without connectors
Weight:	0.7 oz. (19.6 g) without optional shield
Connectors:	RF: SMB I/O: 8-pin (2x4), 0.100” header
ROHS Status:	This product is lead free/ROHS compliant.


Accessories
	Bullet III Antenna 5V or 3.3V versions available Designed for fixed mounting via standard 3/4" pipe thread Optional cable and adapters available 35 dB ± 3 dB gain Dimensions: 77.5 mm x 66.2mm Weight: 170g Part number: 57861-00 Bullet III 3.3V TNC This product is lead free/ROHS compliant. See here for more details

	Hard Mount GPS Antenna Compact, hard mount, active micropatch antenna 5V or 3.0V versions available TNC connector 28dB gain Dimensions: 62.6 mm x 19.0 mm Weight: 180g Part number - 3.0V: 70228-00 This product is lead free/ROHS compliant. See here for more details

	Miniature 3.3V GPS Antenna (packaged) Compact, active micropatch antenna with 5-meter cable MCX or SMA connector Magnetic mount 27 dB ± 3 dB gain 2.7V to 3.3V operation Dimensions: 30.8mm L x 35.8 mm W x 11.8 mm H Weight: 100g with cable Part number - 66800-50 (MCX connector) Part number - 66800-52 (SMA connector) This product is lead free/ROHS compliant. See here for more details

	Embedded 3.3V GPS Antenna (unpackaged) Compact, active miniature unpackaged antenna with 80mm cable HFL connector 27 dB ± 3 dB gain 2.7V to 3.3V operation Dimensions: 22 mm W x 21 mm L x 8 mm H Weight: 20g with cable Part number - 66801-00 This product is lead free/ROHS compliant. See here for more details

	iQ/SQ MCX Transition cable HFL to MCX adapter MCX connector suitable for bulkhead mount Connects Lassen iQ/SQ modules to MCX antennas Length 100mm Part number - 58542 This product is lead free/ROHS compliant.

	iQ/SQ SMA Transition cable HFL to SMA adapter SMA connector suitable for bulkhead mount Connects Lassen iQ/SQ modules to SMA antennas Length 129mm Part number - 58541-05 This product is lead free/ROHS compliant.

Ordering Details:
Board:	46240-25 Lassen iQ module, in metal enclosure, HFL connector Not for new designs - last time buy in effect - last time buy May 18th 2012 for delivery by December 31 2012. Please consider the Condor or Copernicus II as a replacement product (For reference, the old non ROHS compliant part numbers were 46240-10 & 46240-20) Please note that boards are supplied with no cables, software or manuals. Software/manuals are available electronically.
Accessories:	ROHS compliant parts (old non-ROHS part number in brackets): 51099-05 (51099-00) Lassen iQ starter Kit (see below for details) FFSD-04-S-06-01 8 pin data cable to flying leads, 150mm length 58542 (47274) Lassen SQ/iQ Antenna Transition Cable, MCX to HFL, length 100mm 58541-05 (49894-05) Lassen SQ/iQ Antenna Transition Cable, SMA to HFL, length 129mm 66800-50 3.0V, 27dB GPS antenna, mag mount, 5 meter cable, MCX connector 66800-52 3.0V, 27dB GPS antenna, mag mount, 5 meter cable, SMA connector 66801-00 3.0V, 27dB GPS antenna, 80mm cable, HFL connector, unpackaged 57861-00 Bullet III 3.3V GPS antenna TNC connector, 30dB gain 70228-00 3.0V Hardmount GPS Antenna with TNC connector, 28 dB gain D2478-3001 TNC to TNC, 1 metre using RG-58C/U cable D2478-3008 TNC to TNC, 8 metre using RG-58C/U cable D2478-3025 TNC to TNC, 25 metre using RG-58C/U cable D2606-3008 TNC to N-TYPE, 8 metre using RG-58C/U cable D2606-3025 TNC to N-TYPE, 25 metre using RG-58C/U cable D2607-3008 TNC to BNC, 8 metre using RG-58C/U cable D2607-3025 TNC to BNC, 25 metre using RG-58C/U cable D2446-3000 F-Type to F-Type, 25 metres Other cable lengths/connector combinations available on request - call for details Starter kit includes Lassen iQ module mounted on interface board in metal enclosure, compact magnetic-mount antenna, ultra-compact embedded antenna, AC/DC power adapter, serial interface cable, reference manual & GPS software tool kit on CD-ROM.
	ORDER ONLINE - this product and accessories are available to order on our online webshop.
Further Information:	Want further information or pricing on this product? Either fill out our feedback form or contact us for further information.

Home - About Us - Contact - Exhibitions - Feedback - News/Press Releases - Ordering - Products - RSS Feed - Support - Twitter